Fostex D-160 - Manual (Page 106)

D-160 Owner's Manual (Saving and loading data)
106
9 10 11 12 13 14 15 5 6 7 8 16
1 2 3 4 5 6 7 8 1 2
9~16 1~8 9~6
DATA
OUTPUT INPUT
1~8
OPTICAL
INPUT OUTPUT THRU
ANALOG IN ANALOG OUT SCSI MIDI
TO RAIN OR MOISTURE. SHOCK. DO NOT EXPOSE THIS EQUIPMENT
TO REDUCE THE RISK OF FIRE OR ELECTRIC
WARNING:
NE PAS OUVRIR :RISQUE DE CHOC ELECTRIQUE AVIS
DO NOT OPEN RISK OF ELECTRIC SHOCK
CAUTION
4 3
2. Loading the data using DATA IN
* Restore the initial settings on the D-160.
* Set the same sampling rate on the external digital device and the D-160.
Connecting the external device
Connect DATA INPUT 1-8 connectors of the D-160 to the digital output connectors on the
external digital device.
<Notes>
* The D-160 has DATA INPUT connectors for an S/P DIF digital signal (OPTICAL) and for an adat
digital signal. These connectors have the same shape but carry different information.
* Use the DATA INPUT 1-8 connector to load data. Do not use the DATA INPUT 9-16 connector.
* When save/load using DAT and adat, independent save/load in 8 track units is possible. In
this case, the data in 8 track units are not distinguished as track 1~8 or 9~16 but simply
handled as eight track data. Therefore, as this 8 track data is compatible with D-90 if it is in 8
track units (any one combination of 1~8, 9~16 or 17~24), data saved from D-160 can be
loaded in tracks 1~8 of the D-90. In this case, data in the tracks which was not loaded will
remain intact.
• If the external device has only COAXIAL type (RCA) digital I/O connectors, connect an
optional COP-1 (optical/coaxial converter) to use an S/P DIF digital signal.
• Connecting both output and input connectors on the D-160 to the input and output
connectors on the external digital device respectively may generate a digital loop.
Refer to “4-3. Connecting a digital mixer” on page "65" for more information.
Setting up an external device
1. Setup the external device so that it can output a digital signal.
2. Locate the beginning of the pilot signal recorded in the saved data.
* Refer to the instruction manual that came with your external digital device for details.
Executing the load operation
You will use the “Load PGM ?” menu in Setup mode.
* Input format available: adat, DAT, SCSI
* Programs available: P1 - P99
* You can load one saved Program at a time.
1. Press the DISP SEL key to select “SETUP” (“SETUP” will flash) and press the EXECUTE/YES
key. (“SETUP” will light up.)
The D-160 will enter the Setup mode.
2. Use the JOG dial to select “Load PGM ?” (“?” will flash.).
3. Press the EXECUTE/YES key.
The message “Load Device?” and the type of digital signal to be loaded (“DAT,” “adat,” or “SCSI”)
will flash on the display.
DIGITAL OUT
DATA INPUT 1-8
External Digital Equipment (DAT or RD-8 or Adat)
D-160