Fostex D-160 - Manual (Page 113)

D-160 Owner's Manual (Saving and loading data)
113
The number on the right of the slash (/) is the number of all Programs, and the number on the
left is the number of Programs that can be saved.
For example, “03/03” means that all three Programs can be saved. “01/03” means that one
Program out of three Programs can be saved.
“00/03” means that no Programs can be saved. If you press the EXECUTE/YES key at this point,
“Void Command!” appears and you cannot proceed with the save operation.
If you have selected “Save All”, you cannot use multiple disks to save. In this case, chose the save
operation for an individual Program.
3. Press the EXECUTE/YES key (“SAVE” light up.)
Data will be saved as Song data. Therefore, Program 1 (P1) on the internal hard disk will be saved
as Song 1 (S1), Program 2 (P2) as Song 2 (S2).
After the save operation is complete, “COMPLETED!” lights up. Press the STOP button or the
EXIT/NO key to return to the previous Time Base display.
<Notes>
* You cannot abort a save operation while it is in progress.
* To enter title for a SCSI disk, go to “2-20. Drive Sel.?” menu in Setup mode and change
the current drive to “SCSI,” then go to “2-4. Title Edit?” menu in Setup mode to enter
the title.
<Note>
If an error occurs during execution of save and "Error 35" appears in the display, carry out
the following steps:
1 1 1 1 1 . Press the EXIT/NO key.
"Retry?" will appear in the display.
2 2 2 2 2
. If save is to be executed again, press the EXECUTE/YES key upon display of "Retry?."
Save will be executed again.
If ALL save was carried out in this process, save will be executed again from where the
error occurred. Also, if several disks are used for the save, it will save again from the
head of the disk in which the error occurred.
3 3 3 3 3
. If it is to be canceled without executing save, press the EXIT/NO key upon display of
"Retry?."
Loading Song data
Use the “Load PGM?” menu in the Setup mode to load Song data.
* Input format available: adat, DAT, SCSI
* Programs available: P1 - P99, ALL
* You can save one Program or all Programs at a time.
1. Press the DISP SEL key to select “SETUP” (“SETUP” will flash) and press the EXECUTE/YES
key. (“SETUP” will light up.)
The D-160 will enter the Setup mode.
2. Use the JOG dial to select “Load PGM?” (“?” will flash.).
3. Press the EXECUTE/YES key. (“LOAD” will light.)
An indication of the type of the digital signal to be loaded will flash on the display.
44.1kHz
SETUP
LOAD 9 10 11 12 13 14 15 16 8 7 6 5 4 3 2 1
42
OL
0
30
24
18
12
9
6
3
∞
_
4. Rotate the JOG dial to select a flashing “SCSI.”
5. Press the EXECUTE/YES key.
The external digital device is set to “SCSI,” and the existing Song numbers will flash on the
display. (i.g.: “S01[*******” with “01” flashing.)