Fostex D-160 - Manual (Page 114)

D-160 Owner's Manual (Saving and loading data)
114
6. Rotate the JOG dial to select the data to load.
You can choose to load any existing Song individually or all Songs collectively.
The display indication differs as follows depending on whether you selected an individual Song
number or all Song numbers.
* If you have selected an individual Song:
e.g.: You have selected Song 2.
S02[*****
(**** is title)
* If you have selected all Songs:
e.g.:
Load ALL (**/**)
(**=**)
7. Press the EXECUTE/YES key. (“SURE?” flashes.)
Now you can select a Program to load data into.
* If you have selected an individual Song number:
The D-160 will indicate the destination Program number on the internal hard disk. Use the JOG
dial to select a desired destination Program number into which to load data.
If you select a destination Program that already has data, pressing the EXECUTE/YES key will
execute the load operation and the loaded data will overwrite the existing data in the Program.
If you do not want to overwrite the existing data, use the JOG dial to select “New PGM.”
* If you have selected “Load All?(**/**):
The D-160 will indicate the destination Program number on the internal hard disk. Use the JOG
dial to select a desired destination Program number into which to load data.
If the destination hard disk already contains data and you select a Program, “DEL” (Delete)
appears following the Program number.
This is because the “Load All” operation will first erase any Program data on the disk before
loading Song data.
Pressing the EXECUTE/YES key at this point will cause “Delete All PGM?” (deleting all Programs)
to appear, and then “SURE?” will flash.
8. Press the EXECUTE/YES key.
Song data will be loaded to the selected Program.
For example, if Song 1 (S01) is loaded into Program 1 (P01), the D-160 will display “S01>>P01-
***MB” and “REMAIN” will light up. The remaining data to be loaded will count down on the
display as the load operation progresses.
During the all Program load operation, Songs are loaded into Programs sequentially; that is, Song
1 into Program 1, Song 2 into Program 2. (The display changes will correspond to this sequence:
“S01>>P01-***” --> “S02>>P02-***”, etc.)
When the load operation is complete, “COMPLETED!” will light and the D-160 will display the
Time Base that was shown before the unit entered the Setup mode.
9. Press the STOP button or the EXECUTE/YES key, and “COMPLETED!” will turn off.
<Notes>
* You cannot abort a load operation on a SCSI device while it is in progress.
* To enter a title for the SCSI disk, go to “2-20. Drive Sel.?” menu in Setup mode and change
he current drive to “SCSI,” then go to “2-4. Title Edit?” menu in Setup mode to enter the
title.
Loading Backup data
As an example here, we will load the data of a Program saved onto two removable disks.
1. Insert the first disk (Disk-1) into the SCSI device.
2. Follow Steps 1-4 of the “Loading Song data” procedure.
3. Select “SCSI” and press the EXECUTE/YES key. (“LOAD” lights up).
The external digital device is set to “SCSI”. The display flashes the number of the existing Backup
data in the SCSI disk, and then indicates that the first disk has been inserted.