Fostex D-160 - Manual (Page 180)

D-160 Owner's Manual (MMC/FEX List/Maintenance/Specifications)
180
(<edit message=02 (active)>)" after receiving the command.
After the completion of erase operation, "32 47 (<edit message=01 (completed)>)" will
be transmitted.
If erase cannot be executed due to improper figures of the pre-registered auto punch in
point/auto punch out point, incorrect track section, etc., the corresponding <edit message>
will be replied.
12 49: clipboard play command
When this command is received, D-160 will playback once from the head of the sound
data copied in the clipboard by the copy clip and move clip commands.
Immediately after receiving the command, D-160 will reply with "32 49 (<edit message=02
(active)><count><mmc track>)." The sound data track number is indicated by (mmc
track>.
Upon completion of playback, "32 49 (<edit message=01 (completed) is sent and clipboard
play is ended. If there is no sound data in the clipboard, "32 49 (<edit message=14 (void
data)>)" will be sent and clipboard play operation will be interrupted.
12 4A: undo command
Upon receiving this command, D-160 will revert to the condition prior to editing copy
paste,erase, move paste, cut, redo operation. With completion of undo operation, D-160
will reply with "32 4A (<edit message=01(completed)>)."
If D-160 is not possible to undo, "32 4A (<edit message=00 (no message)>)" will be
replied.
12 4B: redo command
When this command is received, D-160 will return to the condition prior to undo operation.
With completion of redo operation, D-160 will reply with "32 4B (<edit message=01
(completed)>)."
If D-160 is not possible to redo, "32 4B (<edit message=00 (no message)>)" will be replied.
12 4D (<count><mmc track>): move clip command
When this command is received, D-160 will copy (multiple tracks can be copied
simultaneously) the sound data from the pre-registered clipboard in point to the clipboard
out point, as data for move paste operation.
With completion copying the data into the clipboard, D-160 will immediately reply with
"32 4D (<edit message=01 (completed)>)."
If copy cannot be executed by the reason of pre-registered improper clipboard in/clipboard
out point figures or incorrect track section, etc., the corresponding <edit message> will
be replied.
12 4E (<count=01><repeat count>): move paste command
12 4E (<count><repeat count><mmc track>): move paste command
When this command is received, D-160 will paste the sound data which have been move
clipped in the clipboard, for the number of times specified by <repeat count> on the
same track from the pre-registered auto punch in point as the starting point.
At the same time, the move clipped original sound data will be erased (data "0" is written
in). However, when sound data length in the clipboard is less than 10ms, specifying
the <repeat count> will be limited to "01."
Also, by specifying the <mmc track>, paste operation can be executed on other tracks in
mono (one track unit) or stereo units (tracks 1&2, 3&4, 5&6....... 15&16).
Since time corresponding to length of the move clipped sound data is required to complete
the move paste operation, D-160 will immediately reply with "32 4E (<edit message=02
(active)>)" after receiving the command.
Following completion of the move paste operation, "32 4E (<edit message = 01
(completed)>)" will be sent.