Fostex D-160 - Manual (Page 87)

D-160 Owner's Manual (Edit function)
87
3. After setting the value, press the STORE key, then the CLIPBOARD IN key.
The time value will be stored as the Clipboard In time, the edit mode will
disengage, and the display will return to the previous screen.
Entering and storing the CLIPBOARD OUT point
4. Press the RECALL key, and then the CLIPBOARD OUT key (or press only the
CLIPBOARD OUT key). The D-160 will enter the edit mode.
5. Move the cursor to the digit you wish to change using the HOLD/> key or the
SHUTTLE dial, and change the value using the JOG dial.
6. After setting the value, press the STORE key, and then the CLIPBOARD OUT
key.
The time value will be stored as the Clipboard Out time, the edit mode will
disengage, and the display will return to the previous screen.
* To check the stored In/Out points, press the CLIPBOARD IN key and CLIPBOARD
OUT key respectively. The time value you just stored will be shown on the display.
* You can perform steps 1-3 in real-time. (Pressing the STORE key, then the
CLIPBOARD IN key while playing back the recorder will store data.)
Copying the track data after storing the CLIPBOARD IN/OUT points
7. Select the copy track using the RECORD TRACK select keys (you can select
multiple tracks).
* You can select one (mono) track, multiple tracks, or all sixteen tracks.
When using the Copy & Paste function, however, you can change the paste
destination track only when you have selected a mono track, or an odd-numbered
track and the adjacent even-track (i.e.: 1-2, 3-4, or 13-14,15-16).
If you have copied multiple tracks (other than the above combination), the data will
be pasted to the copy source tracks. (track 1-> track 1.........track 3-> track 3 etc.)
8. Press the COPY key.
Upon finishing copying to the clipboard, "Copy Clip"/"COMPLETED!" will appear
in the display and then return to the original time base display.
In this way, the specified part of the sound data of the selected track(s) is
copied to the clipboard.
<Hints>
When you are storing the In/Out points in real-time while using the “BAR/BEAT/
CLK” Time Base, you can store them in steps of beats if the “ Resolution ?” menu
(Bar/Beat Resolution mode ON/OFF) in Setup mode is “On.”
When this bar/beat resolution menu is “On,” the CLK value will be rounded to
“00” (at the beginning of the beat) as soon as you press the STORE key.
This function is useful when you wish to use the Copy & Paste or Move & Paste
function in setups of beats. Refer to page “160” for detailed operation.