Fostex D-160 - Manual (Page 63)

D-160 Owner's Manual (Recording/Playback)
63
9 10 11 12 13 14 15 5 6 7 8 16
1 2 3 4 5 6 7 8 1 2
9~16 1~8 9~6
DATA
OUTPUT INPUT
1~8
OPTICAL
INPUT OUTPUT THRU
ANALOG IN ANALOG OUT SCSI MIDI
TO RAIN OR MOISTURE. SHOCK. DO NOT EXPOSE THIS EQUIPMENT
TO REDUCE THE RISK OF FIRE OR ELECTRIC
WARNING:
NE PAS OUVRIR :RISQUE DE CHOC ELECTRIQUE AVIS
DO NOT OPEN RISK OF ELECTRIC SHOCK
CAUTION
4 3
4-2. Digital recording to an external digital device
This section explains how to record a digital data from the D-160 to an external
digital device
* Restore the default settings on the D-160.
Connecting an external digital device
Connect the DATA OUTPUT connector of the D-160 with the digital input of an
external digital device.
<Note>
The D-160 switches the DATA OUTPUT connector between the S/P DIF digital signal
(OPTICAL) and the adat digital signal during setting of the digital input track in Setup
mode. Both signals use the same connector configuration, but carry different data.
When S/P DIF digital signals are to be output, DATA OUTPUT 1-8 only should be used,
and when "adat" digital signals are to be output, either DATA OUTPUT 1-8 or 9-16 must
be used.
D-160
External Digital Equipment External Digital Equipment
DATA OUTPUT1-8 DATA OUTPUT1-8 or 9-16
adat In Digital In (S/P DIF)
* If the external device has only a coaxial (RCA) type digital output connector,
use an optional COP-1 optical/coaxial converter to connect the device to transmit
an S/P DIF digital signal. The operation is the same as that for a device with a
coaxial connector.
* If you connect both the digital input and output of the D-160 to those of an
external digital device, a digital loop might be generated.
Refer to “4-3. Connecting a digital mixer” for more information.
Selecting a playback Program
Selecting the playback Program.
Refer to "2-2. Program Change" section for more information.
* Refer to “2-1. Setting a Program” , "2-2. Program Change" and "2-3. Deleting a
Program" for more information on Programs.
Setting the sampling rate for a playback Program
You need to set the sampling rate of a playback Program to match that of the
digital device before recording digital data.
*****IMPORTANT*****
When a digital signal is output from the D-160, be sure to match the sampling rate of the
external digital device to that of the D-160. If the sampling rate setting does not match,
you cannot record the S/P DIF digital signal and noise may be generated.
Refer to “2-4. Setting a sampling rate” for more information on how to check the sampling
rate of the selected Program. You can also check the rate via the 48kHz indicator located
above the display.