Fostex D-160 - Manual (Page 97)

D-160 Owner's Manual (Edit function)
97
3-1. How to Erase data for a specific part between ABS 0 and ABS END
Storing the erase start point (Auto Punch In point) and the erase end point (Auto Punch Out point)
Refer to “1. Storing memory data,” to set the Auto Punch In/Out points.
Here, we use the procedure to “edit the stored data.”
9
1, 5
2, 6
1, 4
5, 8
1. Press the AUTO PUNCH IN key. (Or, press the RECALL key, then press the AUTO PUNCH IN
key.)
The time value of the Auto Punch In point (bar/beat/clock) appears and the D-160 will enter the
data edit mode.
2. Use the HOLD/> key or the SHUTTLE dial to move among the digits of the time value (bar/beat/
clock), and use the JOG dial to change the value.
3. Press the STORE key. (The STORE LED lights up.)
4. Press the AUTO PUNCH IN key.
The changed time value (bar/beat/clock) is stored as a new Auto Punch In point, and the Time
Base indication will appear on the display. (The STORE LED turns off.)
5. Press the AUTO PUNCH OUT key. (Or, press the RECALL key, then press the AUTO PUNCH
OUT key.)
The time value of the Auto Punch Out point (bar/beat/clock) will appears and the D-160 will
enter the data edit mode.
6. Use the HOLD/> key or the SHUTTLE dial to move among the digits of the time value (bar/beat/
clock), and use the JOG dial to change their value.
7. Press the STORE key. (The STORE LED lights up.)
8. Press the AUTO PUNCH OUT key.
The changed time value (bar/beat/clock) is stored as a new Auto Punch Out point, and the Time
Base indication appears on the display. (The STORE LED turns off.)
* To check the Auto Punch In/Out points, press the ATUO PUNCH IN/OUT keys
respectively. Or, press the RECALL key, and then press the AUTO PUNCH IN/OUT keys
respectively. The display will indicate the time value (bar/beat/clock) stored for the Auto
Punch In point or Auto Punch Out point.
Executing the erase operation
9. Press the RECORD TRACK select key for any track(s) you wish to erase (up to 16 tracks) so that
the corresponding track(s) enter “READY” mode.
10. Press the ERASE key.
The message “Erase” appears on the display, and “SURE?” flashes.
11. Press the EXECUTE/YES key.
This executes the erase operation. The display will indicate “Wait Erasing!”. When the erase
operation is complete, the message “COMPLETED!” will light along with the message “Erase.”
10
11
3, 7
SHIFT
AUTO
CLIPBOARD PLAY
LOCATE ABS 0
DIGITAL MULTITRACK RECORDER
D-160
IN / OUT
PUNCH
PGM CHANGE
8/16 7/15 6/14 5/13 4/12 3/11 2/10 1/9
RECORD TRACK
HD ACCESS LOCKED MTC IN
END IN OUT START
AUTO PUNCH
AUTO PLAY IN OUT
AUTO RTN
CLIPBOARD
PASTE MOVE COPY
AUTO RTN
ERASE UNDO REDO
DISP SEL
EXECUTE
/YES
EXIT
/NO
HOLD/ STORE RECALL
TIME BASE SEL
TAKE
REHEARSAL LOCATE PUNCH
F FWD REWIND PLAY STOP RECORD
VARI PITCH
LOCATE ABS END