D-160 (slave), D-160 owner's manual (midi sync function), Connection to external equipment – Fostex D-160 User Manual
Page 127: Setup of external equipment, Setup of d-160 1, Sequence software is setup as follows
D-160 Owner's Manual (MIDI sync function)
127
POWER
SHIFT
AUTO
CLIPBOARD PLAY
LOCATE ABS 0
DIGITAL MULTITRACK RECORDER
D-160
IN / OUT
PUNCH
PGM CHANGE
8/16
7/15
6/14
5/13
4/12
3/11
2/10
1/9
RECORD TRACK
HD ACCESS
LOCKED
MTC IN
END
IN
OUT
START
AUTO PUNCH
AUTO PLAY
IN
OUT
AUTO RTN
CLIPBOARD
PASTE
MOVE
COPY
AUTO RTN
ERASE
UNDO
REDO
DISP SEL
EXECUTE
/YES
EXIT
/NO
HOLD/
STORE
RECALL
TIME BASE SEL
TAKE
REHEARSAL
LOCATE
PUNCH
F FWD
REWIND
PLAY
STOP
RECORD
VARI PITCH
LOCATE ABS END
4. External MIDI equipment sync system by the slave mode
Up to this point, synchronization with external MIDI equipment has been explained with
the D-160 as the master and MIDI equipment as the slave but depending on the slave
mode setting, the MIDI equipment can be set as the master and D-160 as the slave.
* Initialize D-160.
* Confirm the program and sampling frequency.
* In the following, the explanation will be on the assumption that a computer (with sequence
software) is used.
MIDI OUT
MIDI IN
Computer
with MMC/MTC
soft ware (Master)
D-160 (Slave)
Connection to external equipment
Connect MIDI OUT of the computer (with MIDI interface) with MIDI IN of D-160.
The computer sequence software complying to MMC/MTC must be activated.
Setup of external equipment
Sequence software is setup as follows.
* Set for output of MTC.
* Set frame rate of the MTC to be output.
* Confirm start time of the tune.
# Refer to Owners Manual of the respective equipment for details.
Setup of D-160
1
. Set to same frame rate as the sequence software by the SETUP mode "MTC Frame rate setting."
# Refer to page "151", SETUP mode "2-9. MTC Frame rate setting" for operating
procedure and details.
2
. Set to the desired mode by the SETUP mode "MTC offset mode setting."
# Refer to page "153", SETUP mode "2-11. MTC offset mode setting" for operating
procedure and details.
3
. A random offset time can be set by the SETUP mode "MTC offset time setting."
<Note>
External MIDI equipment which can be used as the master is limited to those which
can output MTC.