Fostex D-160 - Manual (Page 111)

D-160 Owner's Manual (Saving and loading data)
111
Song
Backup
"S**"
"B**"
Name of data saved in the SCSI disk:
The D-160 manages data in the internal IDE hard disk using the name “Program” (such as
Program 1, Program 2, etc. which appears on the display as P01, P02, etc.). Data on the
SCSI disk is termed “Song” or “Backup” to differentiate it from Program data.
When you format a SCSI disk, Song #1 is created on the disk. When you switch the
current drive from “IDE” to “SCSI,” the D-160 will display “S01.”
When you save data from the D-160 to the SCSI disk, the data is treated as “Song” or
“Backup,” depending on how you saved the data.
How to save data Name Display
When one or all Programs were saved to one fixed
disk or removable disk.
When one Program was saved to multiple
removable disks.
<Note>
You can use multiple removable disks, but not multiple fixed disks to save data.
Saving data of an individual Program
You will use the “Save PGM ?” menu in Setup mode.
* Input format available: adat, DAT, SCSI
* Programs available: P1 - P99, ALL
* You can save one Program or all Programs at once.
1. Press the DISP SEL key to select “SETUP” (“SETUP” will flash), and then press the EXECUTE/
YES key. (“SETUP” will light up.)
The D-160 will enter the Setup mode.
2. Use the JOG dial to select “Save PGM?” (“?” will flash.).
3. Press the EXECUTE/YES key. (“SAVE” lights up.)
The indication of the type of digital signal to be saved will flash on the display.
44.1kHz
SETUP
SAVE
9 10 11 12 13 14 15 16 8 7 6 5 4 3 2 1
42
OL
0
30
24
18
12
9
6
3
∞
_
4. Rotate the JOG dial to select a flashing “SCSI.”
5. Press the EXECUTE/YES key. (“SURE?” flashes.)
The external digital device is set to “SCSI,” and the existing Program numbers will flash on the
display. (e.g.: “P02 [current title...” with “02” flashing.)
6. Rotate the JOG dial to select a Program to save.
You can select any existing Program individually or all Programs (Save All). (Refer to the next
section for information on saving all Programs.)
As mentioned previously, the display indication differs as follows depending on whether the
selected Program to save requires only one removable disk or multiple disks.
* If you have selected a Program that has only the Program number and title indication on the
display:
e.g.:
P02 [#*******
(#***** is current title)
This indication means that saving Program P02 requires only one SCSI fixed or removable disk.