Fostex D-160 - Manual (Page 71)

D-160 Owner's Manual (Locate function)
71
SHIFT
AUTO
CLIPBOARD PLAY
LOCATE ABS 0
DIGITAL MULTITRACK RECORDER
D-160
IN / OUT
PUNCH
PGM CHANGE
8/16 7/15 6/14 5/13 4/12 3/11 2/10 1/9
RECORD TRACK
HD ACCESS LOCKED MTC IN
END IN OUT START
AUTO PUNCH
AUTO PLAY IN OUT
AUTO RTN
CLIPBOARD
PASTE MOVE COPY
AUTO RTN
ERASE UNDO REDO
DISP SEL
EXECUTE
/YES
EXIT
/NO
HOLD/ STORE RECALL
TIME BASE SEL
TAKE
REHEARSAL LOCATE PUNCH
F FWD REWIND PLAY STOP RECORD
VARI PITCH
LOCATE ABS END
4-1. Setting the Auto Return Start/End point
There are two ways to set the Auto Return Start point and End point: one is to hold
and store a desired time value in real-time during playback or while the D-160 is
stopped; the other is to edit and store the desired time.
Storing the Start/End point in real-time
3 6
1, 4
2, 5
1. While the D-160 is playing back or stopped, press the HOLD/> key at the location
you wish to store as the Start point.
The time value obtained when you press the HOLD/> key will be held, and the
D-160 will enter the edit mode.
* The Bar/Beat Resolution menu setting is available when BAR/BEAT/CLK is used
for the Time Base. Refer to page “160” for details.
2. Press the STORE key. (The STORE LED will light up.)
3. Press the AUTO RTN START key.
The time value you held will be stored as the Start point, and the display will go
back to the previous screen that was before the time value was held. The STORE
LED will go off.
4. Press the HOLD/> key again at the location you wish to store as the End point.
5. Press the STORE key. (The STORE LED will light up.)
6. Press the AUTO RTN END key.
The time value you held will be stored as the End point, and the display will go
back to the previous screen before the time value was held.
* In steps 1 and 4 described above, you can press the STORE key instead of the
HOLD/> key, and then press the AUTO RTN START/AUTO RTN END key to set
the data more quickly.