Fostex D-160 - Manual (Page 84)

D-160 Owner's Manual (Punch In/Out)
84
2-3. Undo/Redo of Manual Punch In/Out
* If you press the UNDO key after performing the manual punch in/out operation, the original
sound recorded prior to auto punch in/out will be restored.
* If you press the REDO key after undoing the manual punch in/out operation, the manual punch
in/out data will be restored.
<Note>
You can use the undo/redo functions while the D-160 is in stop mode.
Under the following circumstances, you will be unable to use the undo/redo functions;
1. If you make a new recording,
2. If you make a new edit (copy & paste, move & paste, or erase),
3. If the Auto Punch In point was passed in play or record mode while Auto Punch
mode was on, or
4. If you turned off the power to the D-160, then turned it back on.
5. If you use the Program Change function.
<Note>
Once you perform Punch In/Out recording using a footswitch, you need to stop
the D-160 before performing the next Punch In/Out take.
<Hints>
Besides the foot switch, you can also use the PLAY button and RECORD
button for Manual Punch In/Out recording. (Please note that you can
use these buttons only once.)
1 1 1 1 1 . Start playing back from a point just before the punch in point.
2 2 2 2 2 . At the punch in point, press the RECORD button while holding down the
PLAY button. (Punch In)
3 3 3 3 3 . At the punch out point, press only the PLAY button. (Punch Out)
* You can also rehearse if you "press only the RECORD button" instead
of steps 2 and 3 described above.
<Caution after Punch Out>
At "Take" of punch out, the punch-in recording track will not immediately enter
the repro monitor mode from the input monitor mode but enter the repro monitor
mode about two seconds after mute playback.
This is a functional feature of D-160 and not a malfunction.