Fostex D-160 - Manual (Page 161)

D-160 Owner's manual (SETUP mode)
161
2-18. MIDI Device ID Setting (“Device ID?”)
This mode sets up the MIDI device ID number on the D-160.
The set ID applies to both receiving and transmitting when an external sequence software
controls the D-160 via MMC or the Fostex system Exclusive Message.
This mode is necessary to arm the slave machine record track selectors from the master
machine. The available device ID is between 00 and 99. But, if the D-160 receives a
message with ID No 7F, The D-160 will recognize it and follow the command regardless of
the device ID setting.
* Initial setting : 00
* Available setting : 00 ~ 99
* This setting is applicable to all programs.
* This setting cannot be saved or loaded.
* The setting is memorized even when the power is off.
1. Press the DISP SEL key and choose the flashing SETUP mode on the display. Then, press the
EXECUTE/YES key.
The SETUP display will stop flashing.
2. With the JOG dial, choose “Device ID?”.
The “?” display will start flashing.
The display will also show the current setting. In the case of the initial setting, it will show “00”.
3. Press the EXECUTE/YES key.
The current setting will start flashing “**” which indicates it is ready to change setting.
44.1kHz
SETUP
9 10 11 12 13 14 15 16 8 7 6 5 4 3 2 1
42
OL
0
30
24
18
12
9
6
3
∞
_
4. With the JOG dial, enter a required ID number.
The available setting is from 00 ~ 99.
5. Press the EXECUTE/YES key once again.
The setting will be registered and the display will go back to step 2.
* Press either the STOP button or EXIT/NO key to return from the second step to the
first or to quit SETUP mode. The menu will go backwards each time you press either
key so that you can correct the setting, choose some other SETUP mode or eventually
return to the normal time base display.