Generac Power Systems 8 kW LP - Manual (Page 104)

Part 4
Page 102
DC CONTROL
sEctioN 4.1
DEscriPtioN aND comPoNENts
FEMALE SIDE
MALE SIDE
2 1
1 2
C3
Figure 8. Choke Solenoid Connector Pin Number Identification
menu SyStem naViGation
To get to the MENU, use the "Esc" key from any page.
It may need to be pressed many times before getting
to the menu page. The currently selected menu is
displayed as a flashing word. Navigate to the menu
required by using the +/- keys. When the menu required
is flashing, press the ENTER key. Depending on the
menu selected, there may be a list of choices pre-
sented. Use the same navigation method to select the
desired screen (refer to the Menu System diagram).
CHANGING SETTINGS (EDIT MENU):
To change a setting such as display contrast, go to
the EDIT menu and use the +/- keys to navigate to
the setting to change. Once this setting is displayed
(e.g. Contrast), press the ENTER key to go into the
edit mode. Use the +/- keys to change the setting,
press the ENTER key to store the new setting.
note: if the enter key is not pressed to save the
new setting, it will only be saved temporarily. the
next time the battery is disconnected, the setting
will revert back to the old setting.