Lenovo THINKSERVER RS210 User Manual
Page 101
Table 5. DSA Preboot messages (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.
v
See Chapter 7, “Parts listing, RS210 Types 6531, 6532, 6533, and 6534,” on page 177 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v
If an action step is preceded by “(Trained service technician only),” that step must be performed only by a Trained service
technician.
v
Go to the Lenovo support Web site at to check for technical information, hints, tips, and new
device drivers or to submit a request for information.
Message
number
Component
Test
State
Description
Action
202-802-xxx
Memory
Memory
Stress Test
Failed
General error:
memory size is
insufficient to
run the test.
1.
Make sure that all memory is enabled by checking
the Available System Memory in the Resource
Utilization section of the DSA event log. If
necessary, enable all memory in the Setup utility
(see “Using the Setup Utility” on page 200).
2.
Make sure that the DSA code is at the latest level.
For the latest level of DSA code, go to
3.
Run the test again.
4.
Run the standard memory test to validate all
memory.
5.
If the failure remains, go to the Lenovo Web site
for more troubleshooting information at
202-901-xxx
Memory
Memory
Stress Test
Failed
Test failure.
1.
Run the standard memory test to validate all
memory.
2.
Make sure that the DSA code is at the latest level.
For the latest level of DSA code, go to
3.
Turn off the system and disconnect it from power.
4.
Reseat the DIMMs.
5.
Reconnect the system to power and turn on the
system.
6.
Run the test again.
7.
If the failure remains, go to the Lenovo Web site
for more troubleshooting information at
Chapter 4. Diagnostics
93