Lenovo THINKSERVER RS210 - Manual (Page 183)

The following illustration shows the connectors and LEDs on the rear of the server.
1 Power-cord connector 9 NMI button
2 Serial connector 10 USB 3-4 connector
3 Ethernet 1 activity LED 11 USB 1-2 connector
4 Ethernet 1 link LED 12 Video connector
5 Ethernet 2 activity LED 13 Power supply error LED (amber)
6 Ethernet 2 link LED 14 DC power LED (green)
7 PCI slot 1 15 AC power LED (green)
8 PCI slot 2
You must turn off the server before you connect or disconnect cables.
See the documentation that comes with any external devices for additional cabling instructions. It might
be easier for you to route cables before you connect the devices to the server.
Cable identifiers are printed on the cables that come with the server and optional devices. Use these
identifiers to connect the cables to the correct connectors.
Updating the server configuration
When you start the server for the first time after you add or remove an internal option or external device,
you might receive a message that the configuration has changed. The UEFI Setup Utility program starts
automatically so that you can save the new configuration settings.
Some options have device drivers that you must install. For information about installing device drivers,
see the documentation that comes with each option.
If the server has an optional RAID and you have installed or removed a hard disk drive, see the
documentation that comes with the RAID for information about reconfiguring the disk arrays.
For information about configuring the integrated Gigabit Ethernet controller, see “Configuring the Gigabit
Ethernet controllers” on page 219.
Chapter 6. Replacing FRUs 175