Lenovo THINKSERVER RS210 - Manual (Page 141)

6. Follow the instructions that come with the PCI card to set any jumpers or switches.
Attention:
When you install an PCI card, make sure that it is completely and correctly seated in the
expansion slot in the riser card. Incomplete insertion might cause damage to the riser card, system
board, or the PCI card when you turn on the server.
7. Insert the PCI card 5 into the riser-card assembly, aligning the edge connector on the PCI card
with the connector on the riser-card assembly. Press the edge of the connector firmly into the
riser-card assembly. Make sure that the PCI card snaps into the riser-card assembly securely.
Important:
Make sure that the U-shaped opening in the metal PCI card bracket 4 engages the tab
2 on the expansion-slot bracket 1 .
Attention: When you install an PCI card, make sure that the PCI card is correctly seated in the
riser-card assembly and that the riser-card assembly is securely seated in the riser-card connector on
the system board before you turn on the server. An incorrectly seated PCI card might cause damage
to the system board, the riser-card assembly, or the PCI card.
8. Reinstall the riser-card assembly in the server (see “Installing the riser-card assembly” on page 158).
9. If you have installed a PCI-X riser-card assembly 2 in the server, reconnect the riser-card power
cable 2 to the riser-card assembly.
10. Go to “Completing the FRU replacement” on page 173.
Replacing a USB embedded hypervisor flash device
To replace a hypervisor flash device, complete the following procedures:
Removing a USB embedded hypervisor flash device
To remove a hypervisor flash device, complete the following steps:
1.
Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained
service technicians” on page 115.
Chapter 6. Replacing FRUs 133