Installing the power supply – Lenovo THINKSERVER RS210 User Manual
Page 156
7.
Loosen the captive thumbscrew 3 that secures the power supply to the chassis bottom.
8.
Lift the power supply out of the bay.
9.
If you are instructed to return the power supply, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Installing the power supply
To install the replacement power supply, complete the following steps:
1.
Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained
service technicians” on page 115.
2.
Place the new power supply into the chassis.
3.
Tighten the captive thumbscrew that secures the power supply to the chassis bottom.
4.
Replace the screw that holds the power supply to the rear of the chassis.
5.
Connect the internal power-supply cables from the power supply to the power connectors on the
system board. See “System-board internal connectors” on page 107 for the locations of the power
connectors on the system board.
v
For power supply without advanced energy management, connect the power cables to power
connectors 1 and 2 on the system board.
v
For high-efficient power supply with advanced energy manage, connect the power cables to
power connectors 1, 2, 3, and 4 on the system board.
6.
Route the internal power-supply cables, securing them with the retention-clips.
7.
Test the power supply:
a.
Connect one end of the ac power cord for the new power supply into the connector on the back
of the power supply, and connect the other end of the power cord into a properly grounded
electrical outlet.
b.
Make sure that the standby power LED on the system board is lit (see “System-board LEDs” on
page 112); if the standby power LED is not lit, discontinue this procedure and obtain a new
power supply.
c.
Press the power-control button. Make sure that the power-on LED on the front of the server is lit.
If the server starts, proceed to step 8. If the server does not start, disconnect the ac power cord and
call for service.
8.
Turn off the server and disconnect the ac power cord.
148
ThinkServer ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Hardware Maintenance Manual