Lenovo THINKSERVER RS210 User Manual
Page 80
Table 5. DSA Preboot messages (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.
v
See Chapter 7, “Parts listing, RS210 Types 6531, 6532, 6533, and 6534,” on page 177 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v
If an action step is preceded by “(Trained service technician only),” that step must be performed only by a Trained service
technician.
v
Go to the Lenovo support Web site at to check for technical information, hints, tips, and new
device drivers or to submit a request for information.
Message
number
Component
Test
State
Description
Action
089-901-xxx
CPU
CPU Stress
Test
Failed
Test failure.
1.
Turn off and restart the system if necessary to
recover from a hung state.
2.
Make sure that the DSA code is at the latest level.
For the latest level of DSA code, go to
3.
Run the test again.
4.
Make sure that the system firmware is at the
latest level. The installed firmware level is shown
in the DSA event log in the Firmware/VPD
section for this component. For more information,
see “Updating the firmware” on page 212.
5.
Run the test again.
6.
Turn off and restart the system if necessary to
recover from a hung state.
7.
Run the test again.
8.
Replace the following components one at a time,
in the order shown, and run this test again to
determine whether the problem has been solved:
a.
(Trained service technician only)
Microprocessor board
b.
(Trained service technician only)
Microprocessor
9.
If the failure remains, go to the Lenovo Web site
for more troubleshooting information at
166-801-xxx
IMM
IMM I2C Test Aborted
IMM I2C test
stopped: the
IMM returned
an incorrect
response
length.
1.
Turn off the system and disconnect it from the
power source. You must disconnect the system
from ac power to reset the IMM.
2.
After 45 seconds, reconnect the system to the
power source and turn on the system.
3.
Run the test again.
4.
Make sure that the DSA code is at the latest level.
For the latest level of DSA code, go to
5.
Make sure that the IMM firmware is at the latest
level. The installed firmware level is shown in the
DSA event log in the Firmware/VPD section for
this component. For more information, see
“Updating the firmware” on page 212.
6.
Run the test again.
7.
If the failure remains, go to the Lenovo Web site
for more troubleshooting information at
72
ThinkServer ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Hardware Maintenance Manual