Lenovo THINKSERVER RS210 - Manual (Page 170)

10. Connect the signal cable that is attached to the drive backplane 1 to the ServeRAID controller
connector 2 .
11. Replace the riser-card assembly (see “Installing the riser-card assembly” on page 158).
Note: When you restart the server, you are prompted to import the existing RAID configuration to
the new ServeRAID controller.
12. Go to “Completing the FRU replacement” on page 173.
Replacing the DVD drive cable
To replace the optical drive cable, complete the following procedures:
Removing the DVD drive cable
To remove the DVD drive cable, complete the following steps:
1.
Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained
service technicians” on page 115.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see “Removing and installing the cover” on page 119).
4. Remove the riser-card assembly (see “Replacing the PCI riser-card assembly” on page 157).
5. Remove the DVD drive (see “Replacing a DVD drive” on page 164).
6. From the front of the server, press the cable connector latch 1 and slide the DVD drive cable to the
unlock position; then, slide the cable connector to the right and pull the cable out from the connector.
162 ThinkServer ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Hardware Maintenance Manual