Lenovo THINKSERVER RS210 - Manual (Page 154)

“Updating the firmware” on page 212“Updating the Universal Unique Identifier (UUID)” on page
169“Updating the DMI/SMBIOS data” on page 171 for more information.
Important: Some cluster solutions require specific code levels or coordinated code updates. If the device
is part of a cluster solution, verify that the latest level of code is supported for the cluster solution before
you update the code
To install the system board, complete the following steps:
1. Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained
service technicians” on page 115.
2. Align the system board with the chassis, and replace the screws that secure the system board.
3. Reinstall the microprocessor and heat sink (see “Installing the microprocessor” on page 141).
4. Reinstall the DIMMs (see “Installing a memory module” on page 125).
5. Reinstall the DIMM air baffle (see “Removing and installing the DIMM air baffle” on page 121).
6. If necessary, reinstall ServeRAID-BR10il SAS/SATA controller (see “Installing an IBM
ServeRAID-BR10il SAS/SATA controller” on page 160).
7. Reinstall the PCI riser-card assemblies and PCI cards, if any were installed (see “Installing the
riser-card assembly” on page 158 and “Installing a PCI card” on page 132).
8. Reinstall the virtual media key (see “Replacing the virtual media key” on page 167).
9. Reinstall the hypervisor flash device (see “Installing a USB embedded hypervisor flash device” on
page 134).
10. Reconnect all cables to the system board that were disconnected.
11. Install the cover (see “Removing and installing the cover” on page 119).
12. Slide the server into the rack.
13. Reconnect the power cords and any cables that you removed.
14. Turn on the peripheral devices and the server.
Important: Perform the following updates:
v Either update the server with the latest RAID firmware or restore the pre-existing firmware from a
diskette or CD image.
v Update the UUID (see “Updating the Universal Unique Identifier (UUID)” on page 169.
v Update the DMI/SMBIOS (see “Updating the DMI/SMBIOS data” on page 171).
Replacing the power supply
This procedure is used when replacing a defective power supply.
When you remove or install the power supply, observe the following precautions.
Statement 5:
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
146 ThinkServer ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Hardware Maintenance Manual