Lenovo THINKSERVER RS210 - Manual (Page 123)

Chapter 6. Replacing FRUs
Guidelines for trained service technicians
This section contains information for trained service technicians.
Inspecting for unsafe conditions
Use the information in this section to help you identify potential unsafe conditions in a Lenovo product
that you are working on. Each Lenovo product, as it was designed and manufactured, has required safety
items to protect users and service technicians from injury. The information in this section addresses only
those items. Use good judgment to identify potential unsafe conditions that might be caused by
non-Lenovo alterations or attachment of non-Lenovo features or options that are not addressed in this
section. If you identify an unsafe condition, you must determine how serious the hazard is and whether
you must correct the problem before you work on the product.
Consider the following conditions and the safety hazards that they present:
v Electrical hazards, especially primary power. Primary voltage on the frame can cause serious or fatal
electrical shock.
v Explosive hazards, such as a damaged CRT face or a bulging capacitor.
v Mechanical hazards, such as loose or missing hardware.
To inspect the product for potential unsafe conditions, complete the following steps:
1.
Make sure that the power is off and the power cord is disconnected.
2. Make sure that the exterior cover is not damaged, loose, or broken, and observe any sharp edges.
3. Check the power cord:
v Make sure that the third-wire ground connector is in good condition. Use a meter to measure
third-wire ground continuity for 0.1 ohm or less between the external ground pin and the frame
ground.
v Make sure that the power cord is the correct type.
v Make sure that the insulation is not frayed or worn.
4. Remove the cover.
5. Check for any obvious non-Lenovo alterations. Use good judgment as to the safety of any non-Lenovo
alterations.
6. Check inside the server for any obvious unsafe conditions, such as metal filings, contamination, water
or other liquid, or signs of fire or smoke damage.
7. Check for worn, frayed, or pinched cables.
8. Make sure that the power-supply cover fasteners (screws or rivets) have not been removed or
tampered with.
Guidelines for servicing electrical equipment
Observe the following guidelines when servicing electrical equipment:
v Check the area for electrical hazards such as moist floors, nongrounded power extension cords, power
surges, and missing safety grounds.
v Use only approved tools and test equipment. Some hand tools have handles that are covered with a
soft material that does not provide insulation from live electrical currents.
v Regularly inspect and maintain your electrical hand tools for safe operational condition. Do not use
worn or broken tools or testers.
© Lenovo 2009. Portions © IBM Corp. 2007, 2009. 115