Lenovo THINKSERVER RS210 - Manual (Page 171)

7. Remove the cable from the DVD drive cage connector.
8. Disconnect the DVD drive power cable from the power supply cable.
9. If you are instructed to return the DVD drive cable, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Installing the DVD drive cable
To install the DVD drive cable, complete the following steps:
1.
Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained
service technicians” on page 115.
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables.
3. Align the cable connector with the connector on the rear of the DVD drive cage and press the cable
connector into the DVD drive cage connector until it is firmly seated.
4. Pull the cable connector latch 2 up and hold it there while you slide the cable connector to the lock
position; then, slide the cable connector latch down to lock the cable in place.
The following illustration shows cable routing for the DVD drive cable.
Chapter 6. Replacing FRUs 163