Handling static-sensitive devices – Lenovo THINKSERVER RS210 User Manual
Page 125
Handling static-sensitive devices
Attention:
Static electricity can damage the server and other electronic devices. To avoid damage, keep
static-sensitive devices in their static-protective packages until you are ready to install them.
To reduce the possibility of damage from electrostatic discharge, observe the following precautions:
v
Limit your movement. Movement can cause static electricity to build up around you.
v
The use of a grounding system is recommended. For example, wear an electrostatic-discharge wrist
strap, if one is available.
v
Handle the device carefully, holding it by its edges or its frame.
v
Do not touch solder joints, pins, or exposed circuitry.
v
Do not leave the device where others can handle and damage it.
v
While the device is still in its static-protective package, touch it to an unpainted metal part of the
server for at least 2 seconds. This drains static electricity from the package and from your body.
v
Remove the device from its package and install it directly into the server without setting down the
device. If it is necessary to set down the device, put it back into its static-protective package. Do not
place the device on the server cover or on a metal surface.
v
Take additional care when you handle devices during cold weather. Heating reduces indoor humidity
and increases static electricity.
This chapter provides detailed instructions for replacing FRUs in the server.
Chapter 6. Replacing FRUs
117