Replacing the – Lenovo THINKSERVER RS210 User Manual

Page 162

Advertising
background image

v

Set the power-on password.

v

Reconfigure the server.

Replacing the SAS/SATA hard disk drive back plate or backplane

To replace the SAS/SATA hard disk drive backplane or back plate, complete the following procedures:

Removing the backplane or back plate (3.5-inch drives)

To remove the Serial Attached SCSI (SAS) backplane, which is also referred to as the hot-swap SAS/SATA
backplane, or to remove the simple-swap SATA back plate, complete the following steps.
1.

Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained
service technicians” on page 115.

2.

Turn off the server and peripheral devices, and disconnect the power cords and all external cables.

3.

Remove the server from the rack and place it on a flat, static-protective surface.

4.

Pull the hard disk drives out of the server slightly to disengage them from the backplane or back
plate.

5.

Remove the cover (see “Removing and installing the cover” on page 119).

6.

Lift the backplane or back plate 1 out of the server.

7.

Disconnect the backplane or back plate cables:

v

If the server is a hot-swap model, disconnect the SAS/SATA controller signal cable from the
backplane.

Note:

You might want to disconnect the cable from the SAS/SATA controller first, or remove the

SAS/SATA controller from its connector, to make it easier to disconnect the cable from the
backplane or back plate.

v

If the server is a simple-swap mode that contains a standard SATA back plate, disconnect the SATA
cable from the system board.

v

If the server is a simple-swap model that contains a SATA RAID back plate, disconnect the SAS
signal cable from the SAS/SATA controller.

8.

If you are instructed to return the backplane or back plate, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.

Installing the backplane or back plate (3.5-inch drives)

To install the replacement 3.5-inch hot-swap drives backplane or simple-swap SATA drives back plate,
complete the following steps.

154

ThinkServer ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Hardware Maintenance Manual

Advertising