Nortel Networks 450 - Manual (Page 121)

Installing the BayStack 450 Switch
302401-D Rev 00 2-13
To connect the AC power cord, follow these steps:
1. Plug one end of the AC power cord into the AC power receptacle on the
switch back panel (
Figure 2-8 ).
Figure 2-8. BayStack 450 Switch AC Power Receptacle
2. Plug the other end of the AC power cord into the grounded AC power
outlet (
Figure 2-9 ).
Figure 2-9. Grounded AC Power Outlet
3. See the next section, “Verifying the Installation .”
Cascade Module
Redundant Power
100-240V
47-63Hz~
BS45039A
612FA
kombk.book Page 13 Tuesday, June 29, 1999 3:25 PM