Nortel Networks 450 - Manual (Page 219)

Using the Console Interface
302401-D Rev 00 3-87
Figure 3-37 shows an example of the event log entry for this type of event.
Figure 3-37. Sample Event Log Entry Exceeding the Write Threshold
The write threshold is reset when either of the following occurs:
• The BayStack 450 switch is reset.
• The firmware determines that compression is required for maintenance of the
event log’s flash memory.
Flash Update
Figure 3-38 shows an example of the event log entry for this type of event.
Figure 3-38. Sample Event Log Entry Showing Flash Update Status
Entry Number: 3 sysUpTime: 02:29:44 Reset Count: 2
The last event exceeded the write threshold. Further write attempts
by this event are blocked. The write threshold will be cleared when
the switch is reset or when the Event Log is compressed.
Entry Number: 13 sysUpTime: 12:20:38 Reset Count: 2
Flash configuration update operation (write or erase) failed.
Configuration information may be lost.
kombk.book Page 87 Tuesday, June 29, 1999 3:25 PM