Nortel Networks 450 - Manual (Page 53)

BayStack 450 10/100/1000 Series Switches
302401-D Rev 00 1-27
Removing a Unit from the Stack
If a unit is removed from the stack (therefore operating in standalone mode), the
following switch configuration settings revert back to the settings configured
before the unit became a member of the stack:
• IP address
• Console password
• TELNET password
• SNMP community strings
Stack Configurations
As shown in Figure 1-12 , the cascade connectors and cables on the 400-ST1 front
panel provide the ability to stack up to eight BayStack switches. With 400-4TX
MDAs installed in each switch, the stack can accommodate a maximum of 224
switch ports.
Because stack parameters are associated with the base unit (see “Base Unit ” on
page 1-25 ), the physical stack order depends on the base unit’s position and
whether the stack is configured stack up or stack down.
kombk.book Page 27 Tuesday, June 29, 1999 3:25 PM