Nortel Networks 450 - Manual (Page 181)

Using the Console Interface
302401-D Rev 00 3-49
Figure 3-22. Rate Limiting Configuration Screen (2 of 2)
You can use this screen to view the percentage of either packet type (or both
packet types) received on each port.
When the volume of either packet type is high, placing severe strain on the
network (often referred to as a “storm”), you can set the forwarding rate of those
packet types to not exceed a specified percentage of the total available bandwidth.
Rate Limiting Configuration
Unit: [ 1 ]
Port Packet Type Limit Last 5 Minutes Last Hour Last 24 Hours
---- ------------- -------- -------------- --------- -------------
15 [ Both ] [ None ] 44.0% 56.0% 0.0%
16 [ Both ] [ None ] 67.0% 34.0% 0.0%
17 [ Multicast ] [ 10% ] 65.0% 48.0% 45.0%
18 [ Both ] [ None ] 77.0% 74.0% 60.0%
19 [ Both ] [ 10% ] 80.0% 89.0% 90.0%
20 [ Both ] [ None ] 78.0% 83.0% 98.0%
21 [ Broadcast ] [ None ] 98.0% 88.0% 44.0%
22 [ Both ] [ None ] 34.0% 93.0% 0.0%
23 [ Both ] [ None ] 65.0% 82.0% 56.0%
24 [ Multicast ] [ None ] 76.0% 65.0% 50.0%
25 [ Both ] [ 5% ] 88.0% 67.0% 0.0%
26 [ Both ] [ None ] 35.0% 45.0% 90.0%
27 [ Both ] [ None ] 25.0% 48.0% 78.0%
28 [ Both ] [ None ] 17.0% 77.0% 89.0%
Switch[ Both ] [ None ]
Stack [ Both ] [ None ]
Press Ctrl-P to display choices for ports 1-14.
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.
kombk.book Page 49 Tuesday, June 29, 1999 3:25 PM