Nortel Networks 450 - Manual (Page 135)

Using the Console Interface
302401-D Rev 00 3-3
Screen Fields and Descriptions
Figure 3-1 shows a map of the CI screens. The remainder of this chapter describes
the CI screens and their fields, beginning with the main menu.
Figure 3-1. Map of Console Interface Screens
The CI screens for your specific switch model will show the correct model name
in the main menu screen title and the correct number of ports and port types in the
Port Configuration screen.
Note: The field values shown in the CI screens in this section are provided as
examples only.
IP Configuration/Setup
SNMP Configuration
System Characteristics
Switch Configuration
Console/Comm Port Configuration
Identify Unit Numbers
Renumber Stack Units
Display Hardware Units
Spanning Tree Configuration
TELNET Configuration
Software Download
Configuration File
Display Event Log
Reset
Reset to Default Settings
Logout
Main Menu
MAC Address Table
VLAN Configuration
Port Configuration
High Speed Flow Control Configuration
MultiLink Trunk Configuration
Port Mirroring Configuration
Rate Limiting Configuration
IGMP Configuration
Display Port Statistics
Clear Port Statistics
Spanning Tree Port Configuration
Display Spanning Tree Switch Settings
Only appears when the switch is participating in a stack configuration.
Only appears when a gigabit MDA is installed in the Uplink/Expansion Module slot.
VLAN Configuration
VLAN Port Configuration
VLAN Display by Port
Traffic Class Configuration
MultiLink Trunk Configuration
MultiLink Trunk Utilization
BS45041A
1
1
1
2
2
kombk.book Page 3 Tuesday, June 29, 1999 3:25 PM