Nortel Networks 450 - Manual (Page 277)

302401-D Rev 00 F-1
Appendix F
Default Settings
Table F-1 lists the factory default settings for the BayStack 450 switch.
Table F-1. Factory Default Settings for the BayStack 450 Switch
Field Default setting Appears in this CI screen
BootP Request Mode BootP Disabled IP Configuration/Setup ( page 3-8 )
In-Band Stack IP Address 0.0.0.0
(no IP address assigned)
In-Band Switch IP Address 0.0.0.0
(no IP address assigned)
In-Band Subnet Mask 0.0.0.0
(no subnet mask assigned)
Default Gateway 0.0.0.0
(no IP address assigned)
Read-Only Community String public SNMP Configuration ( page 3-13 )
Read-Write Community String private
Trap IP Address 0.0.0.0
(no IP address assigned)
Community String Zero-length string
Authentication Trap Enabled
Link Up/Down Trap Enabled
sysContact Zero-length string System Characteristics ( page 3-15 )
sysName Zero-length string
sysLocation Zero-length string
(continued)
kombk.book Page 1 Tuesday, June 29, 1999 3:25 PM