Nortel Networks 450 - Manual (Page 127)

Installing the BayStack 450 Switch
302401-D Rev 00 2-19
Figure 2-14. IP Configuration/Setup Screen (Standalone Switch)
Enter the IP address of the switch in the In-Band IP Address field, then
press [Return].
4. Enter the IP subnet mask address in the In-Band Subnet Mask field, then
press [Return].
5. Enter the default gateway address in the Default Gateway field, then
press [Return].
See Chapter 3, “Using the Console Interface,” for detailed descriptions of the
menus and screens you can use to customize your configuration.
Note: When you enter the IP address in the In-Band IP Address field, and
the In-Band Subnet Mask field is not present, the software provides an
in-use default value for the In-Band Subnet Mask field, based on the class
of the entered IP address.
IP Configuration/Setup
BootP Request Mode: [ BootP Disabled ]
Configurable In Use Last BootP
------------------- --------------- ---------------
In-Band Stack IP Address: [ 0.0.0.0 ] 0.0.0.0
In-Band Switch IP Address: [ 0.0.0.0 ] 0.0.0.0
In-Band Subnet Mask: [ 0.0.0.0 ] 0.0.0.0 0.0.0.0
Default Gateway: [ 0.0.0.0 ] 0.0.0.0 0.0.0.0
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.
kombk.book Page 19 Tuesday, June 29, 1999 3:25 PM