Nortel Networks Sun Fire V100 - Manual (Page 105)

MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide
Copyright © 2006 Nortel Networks
Powering on the servers
Procedure 29 Powering on the servers
At the server,
1
Turn power on to the server.
2 If the system boots up, log into the server as root.
3 Type init 0 [Enter].
This will bring you to the boot (>ok) prompt. If the system does
not have Solaris installed, it will power up to the >ok prompt. You
may have to send a break to get the >ok prompt. The servers will
more than likely boot up to a Solaris System Identification
screen. Do not answer those questions. Send a break to get to
the >ok prompt so you can then boot from the CD-ROM.
Procedure 30 Power on to get the >ok prompt
At the management pc,
1 If you are using PuTTY, click the program icon in the upper left
PuTTY title bar to access PuTTY’s pull-down menu.
2 Mouse over the telnet command menu item to access additional
drop-down menu options.
3 Select Break to send the break command from the PuTTY
session.
ATTENTION
Do not have any bootp servers on the same subnet of the system.
If there is such a server, disconnect the LAN interface cable from
the system subnet.