Nortel Networks Sun Fire V100 - Manual (Page 177)

MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide
177 Copyright © 2006 Nortel Networks
The only address in this file defines your default gateway route
(your router). If this file is empty and the machine is rebooted,
then you will not have network access to your other servers.
Verifying the Management/Accounting server installation
The following commands are executed on the Management/Accounting
server using PuTTY SSH into the machine logical IP address.
Example: Open a PuTTY SSH session to 192.168.14.11
Procedure 52 Verifying the Management/Accounting server
At the management pc,
1 Log into the server as <nortel/<new nortel user password>.
2 After installing the MCS Base Platform System Software CDs
1-6, execute the following command to verify IP addressing.
@mcsmgmt]/export/home/nortel:=> ifconfig -a
lo0:
flags=1000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4>
mtu 8232 index 1 inet 127.0.0.1 netmask ff000000
dmfe0:
flags=9040843<UP,BROADCAST,RUNNING,MULTICAST,DEP
RECATED,IPv4,NOFAILOVER> mtu 1500 index 2 inet
192.168.14.12 netmask ffffff00 broadcast 192.168.14.255
groupname imspub
dmfe0:1:
flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4
> mtu 1500 index 2 inet 192.168.14.11 netmask ffffff00
broadcast 192.168.14.255
dmfe1:
flags=69040843<UP,BROADCAST,RUNNING,MULTICAST,DE
PRECATED,IPv4,NOFAILOVER,STANDBY,INACTIVE> mtu
1500 index 3 inet 192.168.14.13 netmask ffffff00 broadcast
192.168.14.255 groupname imspub
3 Look for the entry that starts ‘dmfe0.’ The parameters that follow
show the IP address, subnet mask, and whether the interface is
ATTENTION
Refer to the customer-specific information for hostname, IP
addresses, subnet masks, and so on.