Nortel Networks Sun Fire V100 - Manual (Page 51)

MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide
51 Copyright © 2006 Nortel Networks
11 Enter the <machine logical IP addresses of the
servers>
that are the ping targets.
Note: Do not enter the IP address of the server you are
working on.
IP Multipathing needs a set of reliable hosts to ping against.
Select a set of three IP addresses in this subnet that belong to
reliable nodes (such as fault tolerant servers). Select the three
nodes from the following list, in order of preference:
For IPMP GROUPS:
• Machine Logical IP address of the database server
• Machine Logical IP address of the Management server
• Machine Logical IP address of the CAM server
• BPS stack IP address
• Other optional devices (Media Portal host, PRI Gateway
host)
Provide between two and six ping targets for each IPMP group
for proper IPMP failover reliability. Enter the address "0.0.0.0" to
indicate list is complete, if entering less than six targets.
Enter ping target #1: 47.104.27.202
Enter ping target #2: 47.104.27.217
Enter ping target #3: 47.104.27.205
Enter ping target #4: 0.0.0.0
Note: Do not use this server's own IP address as a ping
target.
You will need to press Enter after you enter each IP address.
12 Is this IPMP group configuration acceptable
(Y/N)
Select Y and press Enter.
13 The default route IP address should appear. If correct, press
Enter. Otherwise, type in the correct IP address, then press
Enter.
Note: If your configuration does not include a router, then
enter the machine logical IP address of your server.
14 You are now configuring the Syslog Daemon. [Enter]
15 Does the Management Server have a SysMgr Service Logical IP
Address [Y/N]? Select N.