Nortel Networks Sun Fire V100 User Manual
Page 57
MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide
57
Copyright © 2006 Nortel Networks
Please have the Application Servers (Appsvr,
IPCM, WebSvr, WebClientMgr) Physical IP
addresses and the Machine Logical IP address
ready. Have 6 IP addresses that can be used as
ping buddies. Recommendations for ping buddies
are provided.
6
Press Enter to continue.
7
When you see the IP multipathing configuration for Sun Solaris
information appear, press Enter to accept it or type in a preferred
setting. The default failover timeout is set to 1000mSec.
8
Enter the primary machine physical IP address for the dmfe0
interface: <Physical IP address of the dmfe0
interface of the physical server you are
installing> [Enter]
Example: 192.168.14.32
9
Enter the secondary machine physical IP address for the dmfe1
interface:
<Physical IP address of the dmfe1 interface of
the physical server you are installing> [Enter]
Example: 192.168.14.33
10
Enter the <machine logical IP addresses of the
servers>
that are the ping targets.
Note: Do not enter the IP address of the server you are
working on.
IP Multipathing needs a set of reliable hosts to ping against.
Select a set of three IP addresses in this subnet that belong to
reliable nodes (such as fault tolerant servers). Select the three
nodes from the following list, in order of preference:
For IPMP GROUPS:
•
Machine Logical IP address of the two database servers
•
Machine Logical IP address of the Management server
•
Machine Logical IP address of the CAM server
•
BPS stack IP address
•
Other optional devices (Media Portal host, PRI Gateway
host)
Provide between two and six ping targets or each IPMP group
for proper IPMP failover reliability. Enter the address "0.0.0.0" to
indicate list is complete, if entering less than six targets.