Nortel Networks Sun Fire V100 User Manual
Page 54
NN10287-301 MCS 5100 3.5 Standard 5.0 December 2006
54
Copyright © 2006 Nortel Networks
reliable nodes (such as fault tolerant servers). Select the three
nodes from the following list, in order of preference:
For IPMP GROUPS:
•
Machine Logical IP address of the two database servers
•
Machine Logical IP address of the Management server
•
Machine Logical IP address of the CAM server
•
BPS stack IP address
•
Other optional devices (Media Portal host, PRI Gateway
host)
Provide between two and six ping targets or each IPMP group
for proper IPMP failover reliability. Enter the address "0.0.0.0" to
indicate that the list is complete, if entering less than six targets.
Enter ping target #1: 47.104.27.202
Enter ping target #2: 47.104.27.217
Enter ping target #3: 47.104.27.205
Enter ping target #4: 0.0.0.0
Note 1: Do not use this server's own IP address as a ping
target.
Note 2: Two IP addresses as ping targets are sufficient for the
V100 4-server configuration. Do not enter the router IP or the
server's own IP addresses.
You will need to press Enter after you enter each IP address.
13
Following the configuration that appears, you will see the
message: Is this IPMP group configuration
acceptable (Y/N)?
Select Y if acceptable or N to change.
14
Press Enter to continue.
You will see the following message: Configuring the
default router for the IPMP group
15
The default route IP address should appear. If correct, press
Enter. Otherwise, type it in, then press Enter.
Note: If your configuration does not include a router, then
enter the machine logical IP address of your server.
16
You are now configuring Management/Accounting server
service failover.
[Enter]
You will see the following message: