Netopia 2200 - Manual (Page 214)

214
Link: System Log: Entire
The system log shows the state of the WAN connection as well as the PPPoE session. Ver-
ify that the PPPoE session has been correctly established and there are no failures. If
there are error messages, go to the WAN configuration and verify the settings. The follow-
ing is an example of a successful connection:
Message Log:
00:00:00:00 L3 KS: Using configured options found in flash
00:00:00:00 L3 BOOT: Warm start v7.3r0 ----------------------------------
00:00:00:00 L3 IP address server initialization complete
00:00:00:00 L4 BR: Using saved configuration options
00:00:00:00 L4 BR: Netopia SOC OS version 7.3.0 (build r0)
00:00:00:00 L4 BR: Netopia-3000/9495032 (Netopia-3000, rev 1), PID 1205
00:00:00:00 L4 BR: last install status: Firmware installed successfully
00:00:00:00 L4 BR: memory sizes - 2048K Flash, 8192K RAM
00:00:00:00 L3 BR: Starting kernel
00:00:00:00 L3 AAL5: initializing service
00:00:00:00 L4 ATM: Waiting for PHY layer to come up
00:00:00:00 L3 POE: Initializing PPP over Ethernet service
00:00:00:00 L4 POE: Binding to Ethernet (ether/vcc1)
00:00:00:00 L3 BRDG: Configuring port (10/100BT-LAN)
00:00:00:00 L3 BRDG: Bridge not enabled for WAN.
00:00:00:00 L3 BRDG: Bridging from one WAN port to another is disabled
00:00:00:00 L3 BRDG: Initialization complete
00:00:00:00 L4 IP: Routing between WAN ports is disabled
00:00:00:00 L4 IP: IPSec client pass through is enabled
00:00:00:00 L4 IP: Address mapping enabled on interface PPP over Ethernet vcc1
00:00:00:00 L3 IP: Adding default gateway over PPP over Ethernet vcc1
00:00:00:00 L3 IP: Initialization complete
00:00:00:00 L3 IPSec: initializing service
00:00:00:00 L3 IPSec: No feature key available - service disabled
00:00:00:00 L3 PPP: PPP over Ethernet vcc1 binding to PPPoE
00:00:00:00 L3 PPP: PPP over Ethernet vcc1 Port listening for incoming PPP connection requests
.
.
.
00:00:00:24 L4 RFC1483-1 up
00:00:00:25 L3 Service-Name=ANY
00:00:00:25 L3 Host-Uniq 00000001
00:00:00:25 L3 AC-Name=62011050058192-SMS1800
00:00:00:25 L3 Service-Name=ANY
00:00:00:25 L3 lcp: LCP Send Config-Request+
00:00:00:25 L3 MAGIC 0x2dee0000+
00:00:00:25 L3 lcp: LCP Recv Config-Req:+
00:00:00:25 L3 MRU(1492) (ACK) AUTHTYPE(c223) (CHAP) (ACK) MAGICNUMBER
00:00:00:25 L3 (4403604) (ACK)
00:00:00:25 L3 lcp: returning Configure-Ack
00:00:00:25 L3 chap: received challenge, id 1
00:00:00:25 L3 chap: received success, id 1
00:00:00:25 L3 ipcp: IPCP Config-Request+
00:00:00:25 L3 ADDR(0x0) DNS(0x0) DNS2(0x0) WINS(0x0) WINS2(0x0)
00:00:00:25 L3 ipcp: IPCP Recv Config-Req:+
00:00:00:25 L3 ADDR(143.137.199.254) (ACK)
00:00:00:25 L3 ipcp: returning Configure-ACK
00:00:00:25 L3 ipcp: IPCP Config-Request+
00:00:00:25 L3 ADDR(0x0) DNS(0x0) DNS2(0x0)
00:00:00:25 L3 ipcp: IPCP Config-Request+
00:00:00:25 L3 ADDR(0x8f89c702) DNS(0x8f89320a) DNS2(0x8f898909)
00:00:00:25 L3 ipcp: negotiated remote IP address 143.137.199.254
00:00:00:25 L3 ipcp: negotiated IP address 143.137.199.2
00:00:00:25 L3 ipcp: negotiated TCP hdr compression off
00:00:00:27 L3 NTP: Update system date & time
7/16/03 01:55:31 PM L4 TS: "admin" logging in on serial port 0
7/16/03 01:55:33 PM L4 TS: "Admin" completed login: Full Read/Write access
7/16/03 01:55:33 PM L4 TS: "Admin" completed login: Full Read/Write access