Netopia 2200 - Manual (Page 261)

261
CONFIG Commands
set ip static-routes destination-network net_address
interface { ip-address | ppp-vccn }
Specifies the inter face through which the static route is accessible.
set ip static-routes destination-network net_address
gateway-address gate_address
Specifies the IP address of the Gateway for the static route. The default Gateway must be
located on a network connected to the Netopia Gateway configured inter face.
set ip static-routes destination-network net_address
metric integer
Specifies the metric (hop count) for the static route. The default metric is 1. Enter a num-
ber from 1 to 15 for the integer argument to indicate the number of routers (actual or best
guess) a packet must traverse to reach the remote network.
You can enter a metric of 1 to indicate either:
• The remote network is one router away and the static route is the best way to reach it;
• The remote network is more than one router away but the static route should not be
replaced by a dynamic route, even if the dynamic route is more efficient.
set ip static-routes destination-network net_address
rip-advertise [ SplitHorizon | Always | Never ]
Specifies whether the gateway should use Routing Information Protocol (RIP) broadcasts to
adver tise to other routers on your network and which mode to use. The default is
SplitHo-
rizon.
delete ip static-routes destination-network net_address
Deletes a static route. Deleting a static route removes all information associated with that
route.