Netopia 2200 - Manual (Page 264)

264
set pinhole name name external-port-end [ 0 - 49151 ]
Specifies the last por t number in the range being translated.
set pinhole name name internal-ip internal-ip
Specifies the IP address of the internal host to which traffic of the specified type should be
transferred.
set pinhole name name internal-port [ 0 - 65535 ]
Specifies the por t number your Netopia Gateway should use when for warding traffic of the
specified type. Under most circumstances, you would use the same number for the exter-
nal and internal por t.
PPPoE /PPPoA Settings
You can use the following commands to configure basic settings, por t authentication set-
tings, and peer authentication settings for PPP inter faces on your Netopia Gateway.
Configuring Basic PPP Settings.
☛
NOTE:
For the DSL platform you must identify the vir tual PPP inter face [ vccn], a num-
ber from 1 to 8.
set ppp module [vccn] option { on | off }
Enables or disables PPP on the Netopia Gateway.
set ppp module [vccn] auto-connect { on | off }
Suppor ts manual mode required for some vendors. The default on is not normally
changed. If auto-connect is disabled ( off), you must manually start/stop a ppp connection.