Netopia 2200 - Manual (Page 227)

227
SHELL Commands
diagnose
Runs a diagnostic utility to conduct a series of internal checks and loopback tests to verify
network connectivity over each inter face on your Netopia Gateway. The console displays
the results of each test as the diagnostic utility runs. If one test is dependent on another,
the diagnostic utility indents its entr y in the console window. For example, the diagnostic
utility indents the Check IP connect to Ethernet (LAN) entr y, since that test will not run if
the Check Ethernet LAN Connect test fails.
Each test generates one of the following result codes:
download [ server_address ] [ filename ] [confirm]
This command installs a file of configuration parameters into the Netopia Gateway from a
TFTP (Trivial File Transfer Protocol) ser ver. The TFTP ser ver must be accessible on your
Ethernet network.
You can include one or more of the following arguments with the download command. If
you omit arguments, the console prompts you for this information.
• The server_address argument identifies the IP address of the TFTP ser ver from
which you want to copy the Netopia Gateway configuration file.
• The filename argument identifies the path and name of the configuration file on the
TFTP ser ver.
• If you include the optional confirm keyword, the download begins as soon as all infor-
mation is entered.
Beginning with Firmware Version 7.5.1, you can also download an SSL cer tificate file from
a trusted Cer tification Authority (CA), on platforms that suppor t SSL, as follows:
download [-cert] [ server_address ] [ filename ] [confirm]
CODE Description
PASS The test was successful.
FAIL The test was unsuccessful.
SKIPPED The test was skipped because a test on which it depended failed, or
because the test did not apply to your particular setup or model.
PENDING The test timed out without producing a result. Try running the test again.