Netopia 2200 - Manual (Page 288)

288
Syslog
set system syslog option [ off | on ]
Enables or disables system syslog feature. If syslog option is on, the following commands
are available:
set system syslog host-nameip [ ip_address | hostname ]
Specifies the syslog ser ver’s address either in dotted decimal format or as a DNS name up
to 64 characters.
set system syslog log-facility [ local0 ... local7 ]
Sets the UNIX syslog Facility. Acceptable values are local0 through local7.
set system syslog log-violations [ off | on ]
Specifies whether violations are logged or ignored.
set system syslog log-accepted [ off | on ]
Specifies whether acceptances are logged or ignored.
set system syslog log-attempts [ off | on ]
Specifies whether connection attempts are logged or ignored.
Default syslog installation procedure
1. Access the router via telnet from the private LAN.
DHCP ser ver is enabled on the LAN by default.
2. The product’s stateful inspection feature must be enabled in order to
examine TCP, UDP and ICMP packets destined for the router or the private
hosts.
This can be done by entering the CONFIG inter face.
• Type config
• Type the command to enable stateful inspection