Netopia 2200 - Manual (Page 285)

285
CONFIG Commands
set system password { admin | user }
Specifies the administrator or user password for a Netopia Gateway. When you enter the
set system password command, you are prompted to enter the old password (if
any) and new password. You are prompted to repeat the new password to verify that you
entered it correctly the first time. To prevent anyone from obser ving the password you
enter, characters in the old and new passwords are not displayed as you type them. For
security, you cannot use the “step” method to set the system password.
A password can be as many as 8 characters. Passwords are case-sensitive.
Passwords go into effect immediately. You do not have to restar t the Netopia Gateway for
the password to take effect. Assigning an administrator or user password to a Netopia
Gateway does not affect communications through the device.
set system heartbeat option { on | off }
protocol [ udp | tcp ]
port-client [ 1 - 65535 ]
ip-server [
ip_address | dns_name ]
port-server [ 1 - 65535 ]
url-server ("
server_name ")
number [ 1 – 1073741823 ]
interval (00:00:00:20)
sleep (00:00:30:00)
contact-email ("
string @ domain_name ")
location (" string "):
The hear tbeat setting is used in conjunction with the configuration ser ver to broadcast con-
tact and location information about your Gateway. You can specify the
protocol, port, IP-,
port-, and URL-server.
• The interval setting specifies the broadcast update frequency. Part of sequence con-
trol. The inter val is the spacing between hear tbeats, in d:h:m:s.
• The contact-email setting is a quote-enclosed text string giving an email address for
the Gateway’s administrator.
• The location setting is a text string allowing you to specify your geographical or other
location, such as “Secaucus, NJ.”
• The number setting is part of the sequence control. This is the number of heartbeats
to send, at each “inter val”, before sleeping. For example, if this is 20, in the above lay-