Netopia 2200 - Manual (Page 245)

245
CONFIG Commands
set bridge ethernet option { on | off }
Enables or disables bridging ser vices for the specified vir tual circuit using Ethernet fram-
ing.
set bridge dsl vcc n option { on | off }
Enables or disables bridging ser vices for the specified inter face. Specified inter face must
be par t of a VLAN if bridge is turned
on. Only RFC-1483 Bridged encapsulation is sup-
por ted currently.
• show log command will show that WAN Bridge is enabled when at least one WAN inter-
face is bridged.
• show ip interfaces and show bridge interfaces commands will show the inter faces
that are not in bridged mode and that are in bridged modes, respectively.
set bridge table-timeout [ 30 ... 6000 ]
Sets the timeout value for bridging table timeout. Default = 30 secs; range = 30 secs –
6000 secs (.5–100 mins).
DHCP Settings
As a Dynamic Host Control Protocol (DHCP) ser ver, your Netopia Gateway can assign IP
addresses and provide configuration information to other devices on your network dynami-
cally. A device that acquires its IP address and other TCP/IP configuration settings from the
Netopia Gateway can use the information for a fixed period of time (called the DHCP lease).
Common Commands
set dhcp option { off | server | relay-agent }
Enables or disables DHCP ser vices in the Netopia Gateway. You must enable DHCP ser-
vices before you can enter other DHCP settings for the Netopia Gateway.
If you turn off DHCP ser vices and save the new configuration, the Netopia Gateway clears
its DHCP settings.