Netopia 2200 - Manual (Page 297)

297
CONFIG Commands
set radius radius-port port_number
Specifies the por t on which the RADIUS ser ver is listening. The default value is 1812.
VLAN Settings
These settings are suppor ted beginning with Firmware Version 7.4.2.
You can create up to 32 VLANs, and you can also restrict any VLAN, and the computers on
it, from administering the Gateway. See
“VLAN” on page 106 for more information.
set vlan name string
Sets the descriptive name for the VLAN. If no name is specified, displays a selection list of
node names to select for editing.
Once a new VLAN name is specified, presents the list of VLAN characteristics to define:
• id – numerical range of possible IDs is 1 - 4095
• type [ by-port ] – currently the only selection is by-port
• admin-restricted [ off | on ] – default is off. If you select on, administrative access to
the Gateway is blocked from this VLAN.
• port – VLAN’s physical port or wireless SSID.
You must save the changes, exit out of configuration mode, and restar t the Gateway for the
changes to take effect.
Example:
• Navigate to the VLAN item:
Netopia-3000/9459252 (top)>> vlan
Netopia-3000/9459252 (vlan)>> set
vlan
name
(name) node list ...
Select (name) node to modify from list,
or enter new (name) to create.
name (?): vlan1
(vlan1) has been added to the (name) list
"vlan1"