Netopia 2200 - Manual (Page 279)

279
CONFIG Commands
set security pkt-filter filterset filterset-name [ in | out ] index
frc-rte [ on | off ]
Turns forced routing on or off for the specified filter rule. A match on this rule will force a
route for packets. The default is
off.
set security pkt-filter filterset filterset-name [ in | out ] index
gateway ip_addr
Specifies the gateway IP address for forced routed packets, if forced routing is enabled.
set security pkt-filter filterset filterset-name [ in | out ] index
src-ip ip_addr
Specifies the source IP address to match packets (where the packet was sent from).
set security pkt-filter filterset filterset-name [ in | out ] index
src-mask mask
Specifies the source IP mask to match packets (where the packet was sent from).
set security pkt-filter filterset filterset-name [ in | out ] index
dest-ip ip_addr
Specifies the destination IP address to match packets (where the packet is going).
set security pkt-filter filterset filterset-name [ in | out ] index
dest-mask mask
Specifies the destination IP mask to match packets (where the packet is going).
set security pkt-filter filterset filterset-name [ in | out ] index
tos value
Specifies the TOS (Type Of Ser vice) value to match packets. The value for tos can be from
0 – 255.