Quantum Instruments DLT 7000 - Manual (Page 123)

SCSI Commands
Quantum DLT 7000 Tape System 5-19
INQUIRY Command (12h) (continued)
Table 5–9 Standard Inquiry Data Page - Field Descriptions (continued)
Field Name Value Description
Sync 1 The drive supports Synchronous Data Transfers.
Linked 1 Linked Commands are supported.
CmdQue 0 The drive does not support Tagged Command Queuing.
SftRe 0 The drive implements the hard reset option in response to
assertion of the SCSI Bus reset line.
Vendor Identification The value in this field is QUANTUM (there are spaces after the
word Quantum)
Product Identification The value in this field is DLT 7000 (there are spaces after the
word DLT 7000)
Product Revision Level This field contains 4 bytes of ASCII data that provides the
drive’s software revision levels. The first two bytes are the
version number of servo code. The second two bytes are the
version number of the SCSI/read/write code. When a firmware
update is performed on the DLT drive, this part of the revision
level will change to reflect that update (quotation marks will
not appear).
Vendor Specific See Section 5.4.2 for details.
NOTE: Vendor Information, Product Identification, and Product Revision Level are returned as
shown in Figure 5–5.
5.4.2 Vendor Unique Inquiry Data
The following information can be used to precisely identify the revision of
subsystem components.