Quantum Instruments DLT 7000 - Manual (Page 195)

SCSI Commands
Quantum DLT 7000 Tape System 5-91
MODE SELECT (6) / (10) Command (15h) / (55h) (continued)
Table 5–47 EEPROM Vendor Unique Page Parameters
Name Value
Rep.
Default Length
(Bytes)
Usage
VENDORID ASCII QUANTUM 8 Vendor Identification field in INQUIRY
Data
PRODUCTID ASCII DLT 7000 16 Product Identification field in INQUIRY
Data
CACHETMS ASCII
Decimal
0 1 0,1 = Do not cache filemarks unless
IMMED bit is set (if set)
2 = Cache if not two in a row unless
IMMED bit is 1.
3 = Always cache filemarks.
DEFAULTCOMPON ASCII
Binary
1 1 0 = Compression defaulted OFF at
power-up/reset
1 = Compression defaulted ON at power-
up/reset
DEFIXEDBLKEN ASCII
Decimal
0 8 Default fixed block size
DEFSEW ASCII
Binary
1 1 To set default SEW parameter.
DISDEFERCLNRPT ASCII
Binary
0 1 When set, a cleaning report is sent over
the library port as soon as the cleaning
light illuminates. If this parameter = 0,
then the report is sent only at unload.
DISLDRAUTODMC ASCII
Binary
1 1 To partially disable sequential loading
with loader if any media loader command
has been received.
DISUNBUFMODE ASCII
Binary
0 1 The drive disables unbuffered mode, i.e.,
it ignores the MODE SELECT “buffered
mode” selection to turn off buffered
mode (if set).