Quantum Instruments DLT 7000 - Manual (Page 256)

SCSI Commands
5-152 Quantum DLT 7000 Tape System
REQUEST SENSE Command (03h) (continued)
Table 5–72 Supported ASC / ASCQ in Hex (continued)
Sense Key ASC ASCQ Description
04h 44 C3 Both EEROM Copy Areas Bad
HARDWARE ERROR 47 00 SCSI Parity Error
(cont.) 48 00 IDE Message Received
51 00 Erase Failure
53 00 Media Load/Eject Failure
53 01 Unload Tape Failure
05h 1A 00 Parameter List Length Error
ILLEGAL REQUEST 20 00 Illegal Opcode
20 81 Illegal Command While In Recovery Mode
21 01 Invalid Element Address (Media Changer)
24 00 Invalid CDB Field (may occur if odd block counts
are attempted in fixed mode)
24 81 Invalid Mode on WRITE Buffer
24 82 Media in Drive
24 84 Insufficient Resources
24 86 Invalid Offset
24 87 Invalid Size
24 89 Image Data Over Limit 3
24 8B Image/Personality is Bad 3
24 8C Not Immediate Command
24 8D Bad Drive/Server Image EDC 3
24 8E Invalid Personality for Code Update (CUP) 3
24 8F Bad Controller Image EDC 3
25 00 Illegal LUN
26 00 Parameter List Error, Invalid Field
26 01 Parameter List Error, Parameter Not Supported
26 02 Parameter List Error, Parameter Value Invalid
30 00 Incompatible medium (cannot read medium)
39 00 Saving Parameters Not Supported
3B 0D Media Destination Element Full 1
3B 0E Media Source Element Empty 1
3D 00 Invalid Bits in ID Message
53 02 Media Removal Prevented
82 00 Not Allowed if not at BOT
1 Medium changer specific command.
2 Contact a service representative.
3 Bad firmware image or code download possible.