ZyXEL Communications 200 Series - Manual (Page 204)

Chapter 10 Interface
ZyWALL USG 100/200 Series User’s Guide
204
Status This field displays the current status of each interface. The possible values depend
on what type of interface it is.
For Ethernet interfaces:
Inactive - The Ethernet interface is disabled.
Down - The Ethernet interface does not have any physical ports associated
with it or is enabled but not connected.
Speed / Duplex - The Ethernet interface is enabled and connected. This field
displays the port speed and duplex setting (Full or Half).
For the auxiliary interface:
Inactive - The auxiliary interface is disabled.
Connected - The auxiliary interface is enabled and connected.
Disconnected - The auxiliary interface is not connected.
For virtual interfaces:
Up - The virtual interface is enabled and connected.
Inactive - The virtual interface is disabled.
For VLAN and bridge interfaces:
Up - The the VLAN or bridge interface is enabled and connected.
Inactive - The the VLAN or bridge interface is disabled.
For PPPoE/PPTP interfaces:
Connected - The PPPoE/PPTP interface is connected.
Disconnected - The PPPoE/PPTP interface is not connected.
Inactive - The PPPoE/PPTP interface is disabled.
For WLAN interfaces:
Up - The WLAN interface is enabled.
Down - The WLAN interface is disabled.
HA Status This field displays the status of the interface in the virtual router.
Active - This interface is the master interface in the virtual router.
Stand-By - This interface is a backup interface in the virtual router.
Fault - This VRRP group is not functioning in the virtual router right now. For
example, this might happen if the interface is down.
n/a - Device HA is not active on the interface.
Zone This field displays the zone to which the interface is currently assigned.
IP Addr/Netmask This field displays the current IP address and subnet mask assigned to the
interface. If the IP address and subnet mask are 0.0.0.0, the interface is disabled or
did not receive an IP address and subnet mask via DHCP.
If this interface is a member of an active virtual router, this field displays the IP
address it is currently using. This is either the static IP address of the interface (if it
is the master) or the management IP address (if it is a backup).
IP Assignment This field displays how the interface gets its IP address.
Static - This interface has a static IP address.
DHCP Client - This interface gets its IP address from a DHCP server.
Dynamic - This is the auxiliary interface.
Services This field lists which services the interface provides to the network. Examples
include DHCP relay, DHCP server, DDNS, RIP, and OSPF. This field displays n/a
if the interface does not provide any services to the network.
Action Use this field to get or to update the IP address for the interface. Click Renew to
send a new DHCP request to a DHCP server. Click the Connect icon to try to
connect the auxiliary interface or a PPPoE/PPTP interface. If the interface cannot
use one of these ways to get or to update its IP address, this field displays n/a.
Interface
Statistics This table provides packet statistics for each interface.
Refresh Click this button to update the information in the screen.
Table 48 Network > Interface > Status (continued)
LABEL DESCRIPTION