ZyXEL Communications 200 Series - Manual (Page 802)

Appendix A Log Descriptions
ZyWALL USG 100/200 Series User’s Guide
802
Interface %s does not
belong to any OSPF
area.
Interface %s has been set OSPF authentication same-as-area,
however the interface does not belong to any OSPF area. %s:
Interface Name
Invalid OSPF
authentication of area
%s on interface %s.
Interface %s has been set OSPF authentication same-as-area,
however the area has invalid text authentication configuration. %s:
Interface Name
Table 299 NAT Logs
LOG MESSAGE DESCRIPTION
The NAT range is full The NAT mapping table is full.
%s FTP ALG has
succeeded.
The FTP Application Layer Gateway (ALG) has been turned on or off.
%s: Enable or Disable
Extra signal port of
FTP ALG has been
modified.
Extra FTP ALG port has been changed.
Signal port of FTP ALG
has been modified.
Default FTP ALG port has been changed.
%s H.323 ALG has
succeeded.
The H.323 ALG has been turned on or off. %s: Enable or Disable
Extra signal port of
H.323 ALG has been
modified.
Extra H.323 ALG port has been changed.
Signal port of H.323
ALG has been modified.
Default H.323 ALG port has been changed.
%s SIP ALG has
succeeded.
The SIP ALG has been turned on or off. %s: Enable or Disable
Extra signal port of
SIP ALG has been
modified.
Extra SIP ALG port has been changed.
Signal port of SIP ALG
has been modified.
Default SIP ALG port has been changed.
Register SIP ALG extra
port=%d failed.
SIP ALG apply additional signal port failed.
%d: Port number
Register SIP ALG
signal port=%d failed.
SIP ALG apply signal port failed.
%d: Port number
Register H.323 ALG
extra port=%d failed.
H323 ALG apply additional signal port failed.
%d: Port number
Register H.323 ALG
signal port=%d failed.
H323 ALG apply signal port failed.
%d: Port number
Register FTP ALG extra
port=%d failed.
FTP ALG apply additional signal port failed.
%d: Port number
Register FTP ALG
signal port=%d failed.
FTP ALG apply signal port failed.
%d: Port number
Table 298 Routing Protocol Logs (continued)
LOG MESSAGE DESCRIPTION